EFFECT OF PVD COATED TOOLS ON EUTECTIC ALUMINIUM ALLOY DURING DRY MACHINING PROCESS

Authors

  • Tanmay Thombare1, B.R. Ingale2 Digmber Kashid3 1,2 Department of Mechanical Engineering, Fabtech Technical Campus College of Engineering and Research Sangola. 3 Department of Mecahnical Engineeirng, SVERI COE Pandharpur

Keywords:

Eutectic,, PVD,, HC

Abstract

Aluminium Alloy is widely used in various Industries like Aerospace, Automobile etc. due to their peculiar character weight by volume ratio. Addition Silicon not only increases the strength of the alloy but also helps to perform smooth machining. Silicon in the Al alloy is about 12% is commonly known as Eutectic Al Alloy. Machining is a further challenge for this Eutectic alloy. Dry machining process is an economic and environmental healthy process. In the present study Eutectic Aluminium alloy is machined using PVD coated HC,AlTiN and Uncoated Carbide cutting tool. Minitab statistical software is used to produce L27 Array for 3 factor and 3 levels of variables to conduct turning experiment. Average Surface roughnesses are recorded to optimize the cutting parameters for each tool using Taguchi analysis for the dry machining process. Hard Carbon coated tool machining gives minimum Ra= 0.615 µm at 2000 rpm Speed, 0.02 mm/rev feed rate and 0.25mm depth of cut. The study also shows that coated tools shows appreciable results compared with uncoated tools to achieve optimized surface finish.

 

Published

2022-07-03

Issue

2022: NCRTSAE -JUNE

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Under the Creative Commons Attribution- 4.0 International License (CC BY-4.0 DEED).

You are free to:

  1. Share — copy and redistribute the material in any medium or format for any purpose, even commercially.
  2. Adapt — remix, transform, and build upon the material for any purpose, even commercially.
  3. The licensor cannot revoke these freedoms as long as you follow the license terms.

Under the following terms:

  1. Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
  2. No additional restrictions — You may not apply legal terms or technological measures that legally restrict others from doing anything the license permits.

Notices:

You do not have to comply with the license for elements of the material in the public domain or where your use is permitted by an applicable exception or limitation.

No warranties are given. The license may not give you all of the permissions necessary for your intended use. For example, other rights such as publicity, privacy, or moral rights may limit how you use the material.

How to Cite

Tanmay Thombare1, B.R. Ingale2 Digmber Kashid3. (2022). EFFECT OF PVD COATED TOOLS ON EUTECTIC ALUMINIUM ALLOY DURING DRY MACHINING PROCESS. International Journal of Innovations in Engineering Research and Technology. https://repo.ijiert.org/index.php/ijiert/article/view/3275