ANALYSIS OF TOOL WEAR IN TURNING OPERATION OF ALUMINIUM

Authors

  • MR. NAGESH NARENDRA YEMUL M.E Mechanical (Manufacturing Process) Engineering, A.G. Patil Institute of Technology, Solapur University, Solapur.
  • PROF. DESHPANDE G.R Department of Mechanical Engineering, A.G. Patil Institute of Technology, Solapur Solapur University, Solapur.

Abstract

The present work is the representation of the research work carried out by the authors to analyze tool wear in turning operation of Aluminium.. The objectives of the research was to specify specific speed, feed, depth of cut which results least tool wear while working with aluminium part & HSS tool. Also to find out the maximum & minimum wear occurring on HSS tool at different cutting speeds.

 

Downloads

Published

2021-02-11

Issue

Vol. 8 No. 2 (2021): IJIERT

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Under the Creative Commons Attribution- 4.0 International License (CC BY-4.0 DEED).

You are free to:

  1. Share — copy and redistribute the material in any medium or format for any purpose, even commercially.
  2. Adapt — remix, transform, and build upon the material for any purpose, even commercially.
  3. The licensor cannot revoke these freedoms as long as you follow the license terms.

Under the following terms:

  1. Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
  2. No additional restrictions — You may not apply legal terms or technological measures that legally restrict others from doing anything the license permits.

Notices:

You do not have to comply with the license for elements of the material in the public domain or where your use is permitted by an applicable exception or limitation.

No warranties are given. The license may not give you all of the permissions necessary for your intended use. For example, other rights such as publicity, privacy, or moral rights may limit how you use the material.

How to Cite

MR. NAGESH NARENDRA YEMUL, & PROF. DESHPANDE G.R. (2021). ANALYSIS OF TOOL WEAR IN TURNING OPERATION OF ALUMINIUM. International Journal of Innovations in Engineering Research and Technology, 8(2), 26-32. https://repo.ijiert.org/index.php/ijiert/article/view/1244